Juniper JUNOSE 11.2.X MULTICAST ROUTING, Configuration Manual

Page: 118 / 256

•
Use to display the configuration for SONET and SDH interfaces.
•
Field descriptions
•
Interface specifier in slot/port format (ERX14xx models, ERX7xx models, and the
ERX310 router) or slot/adapter/port format (E120 and E320 routers)
•
non channelized—Unchannelized path
•
channelized—Number of channels and speed for the interface
•
ifAdminStatus—Configured status of the interface: up or down
•
description—Configured description of the controller
•
snmp trap link-status—State of SNMP link-status processing for the section and
line layers of the interface: enabled or disabled
•
alarms used for operational status calculation—Types of defects that the router
uses to determine the operational status of the interface at the section and line
layers
•
defect trigger soaking delay—Time that the router waits to set an alarm when the
router records a defect at the section or line layer
•
Operational Status—Physical state of the interface:
•
up—Interface is operational
•
down, failure alarm—Interface is not operational; type of defect that caused failure
is specified
•
time since last status change—Time since the module was rebooted
•
Loopback State—Type of loopback configured on the interface
•
Mode—Type of interface: SONET or SDH
•
Timing source—Type of clock source configured for the channel:
•
line—Internal clock is from the line module itself
•
chassis—Internal clock is from the configured router clock
•
Receive FIFO Overruns—Number of times received FIFO was overrun
•
Current section defects—Number of suspect bit patterns found in several consecutive
frames in section layer
•
Current line defects—Number of suspect bit patterns found in several consecutive
frames in line layer
•
Received SONET overhead—Section and line overhead bytes present in the receive
side of the interface at any particular time
•
Transmitted SONET overhead—Section and line overhead bytes present in the
transmit side of the interface at any particular time
Copyright © 2010, Juniper Networks, Inc. 96
JunosE 11.2.x Physical Layer Configuration Guide