Juniper JUNOSE 11.2.X MULTICAST ROUTING, Configuration Manual

Page: 189 / 256

CHAPTER 5
Configuring Ethernet Interfaces
This chapter describes how to configure Ethernet interfaces on E Series Broadband
Services Routers.
Most of the procedures described here do not apply to the Fast Ethernet management
port on the SRP module. You can, however, select and display statistics for that port by
using commands described in this chapter. For information about managing the Fast
Ethernet port on the SRP module, see
JunosE System Basics Configuration Guide .
This chapter contains the following sections:
• Ethernet Overview on page 167
•
Ethernet Interface Platform Considerations on page 168
•
Fast Ethernet I/O Modules on page 170
• Gigabit Ethernet I/O Modules and IOAs on page 171
• 10-Gigabit Ethernet IOAs on page 182
•
Ethernet References on page 186
•
High-Density Ethernet on page 187
• Managing Port Redundancy on Gigabit Ethernet I/O Modules on page 188
• Configuration Tasks for Ethernet on page 189
•
Configuring the Physical Interface on page 190
•
Disabling Ethernet Interfaces on page 195
• Monitoring Ethernet Interfaces on page 196
Ethernet Overview
Ethernet modules support the following Ethernet interfaces:
•
Fast Ethernet
• Gigabit Ethernet
• 10-Gigabit Ethernet
This section describes features that are available with Ethernet interfaces.
167 Copyright © 2010, Juniper Networks, Inc.