Juniper JUNOSE 11.2.X MULTICAST ROUTING, Configuration Manual

Page: 35 / 256

•
Specify the keywords internal module to use the line module’s internal clock as the
transmit clock.
•
Specify the keywords internal chassis to use the router’s clock as the transmit clock.
•
Example
host1(config-controll)# clock source internal module
•
Use the no version to revert to the default, line .
•
See clock source.
description
•
Use to assign a text description or an alias to a channelized T3 interface.
•
You can use this command to help you identify the interface and keep track of interface
connections.
•
The description or alias can be a maximum of 80 characters.
•
Use “show controllers t3” on page 29 to display the text description.
•
Example
host1(config-controll)# description toronto ct3 interface
•
Use the no version to remove the text description or alias.
•
See description.
framing
•
Use to configure the framing format for a T3 controller.
•
Specify either m23 or c-bit framing.
•
Choose the framing format that is compatible with the framing format of the Telco
network device at the other end of the line.
•
Select c-bit framing if you intend to configure MDL messages.
•
Example
host1(config-controll)# framing c-bit
•
Use the no version to restore the default value, c-bit .
•
See framing.
snmp trap ip link-status
•
Use to enable SNMP link status processing on a T3 controller.
•
Example
host1(config-controll)# snmp trap link-status
•
Use the no version to disable SNMP link status processing.
•
See snmp trap ip link-status.
13 Copyright © 2010, Juniper Networks, Inc.
Chapter 1: Configuring Channelized T3 Interfaces