Juniper JUNOSE 11.2.X MULTICAST ROUTING, Configuration Manual

Page: 216 / 256

•
Use to select a 10-Gigabit Ethernet interface on the E120 or E320 router.
NOTE: On the ES2-S2 10GE PR IOA, you can configure only the primary port, 0. The
router automatically uses the redundant port, 0R, if the primary port fails.
•
Use the slot/adapter/port format.
•
Example—Selects a 10-Gigabit Ethernet interface on the ES2-S1 10GE IOA
host1(config)# interface tenGigabitEthernet 4/0/0
•
Use the no version to remove IP from an interface. You must issue the no version from
the highest level down; you cannot remove an interface or subinterface if the one above
it still exists.
•
See interface tenGigabitEthernet.
ip mac-validate
•
Use to enable or disable MAC address validation on a per interface basis.
•
Use the strict keyword to prevent transmission of IP packets that do not reside in the
validation table.
•
Use the loose keyword to enable IP packets to pass through even though the packets
do not have entries in the validation table. Only packets that have matching IP–MAC
pair entries in the table are validated.
•
The default behavior is not to perform MAC address validation.
•
Example
host1(config)# interface gigabitEthernet 2/0
host1(config-if)# ip address 4.4.4.2 255.255.255.0
host1(config-if)# ip mac-validate strict
host1(config-if)# exit
•
Use the no version to disable the command.
NOTE: For additional information about MAC address validation, see the arp validate
command description in JunosE IP, IPv6, and IGP Configuration Guide.
•
See ip mac-validate.
load-interval
•
Use to set the time interval at which the router calculates bit and packet rate counters.
•
This command does not work for the Fast Ethernet port on the SRP module.
•
Specify a multiple of 30 seconds, in the range 30–300 seconds.
•
The default value is 300 seconds.
•
Example
Copyright © 2010, Juniper Networks, Inc. 194
JunosE 11.2.x Physical Layer Configuration Guide