Juniper JUNOSE 11.2.X MULTICAST ROUTING, Configuration Manual

Page: 147 / 256

•
Use to configure an FDL message as defined in the ANSI T1.403 specification.
NOTE: The router sends these FDL messages only if you have issued the path ds1 fdl
command with the ansi or all keyword and then issued the path ds1 fdl transmit
command.
•
Example
host1(config-controll)# path 2 ds1 1/1/1 fdl string eic "ERX1440"
•
Use the no version to restore the default value to the specified FDL message or to all
FDL messages.
•
See path ds1 fdl string.
path ds1 fdl transmit
•
Use to configure the router to send the specified type of FDL message on the T1 channel.
•
By default, the router sends no FDL messages.
NOTE: The router sends FDL messages specified with the path ds1 fdl string command
only if you have issued the path ds1 fdl command with the ansi or all keyword. If you
specified the att keyword with the path ds1 fdl command, the router sends only
performance data.
•
Specify the keyword path-id to transmit path identifications every second.
•
Specify the keyword idle-signal to send idle signals every second.
•
Specify the keyword test-signal to transmit test signals every second.
•
Example
host1(config-controll)# path 2 ds1 1/1/1 fdl transmit path-id
•
Use the no version to disable transmission of the specified FDL message or all FDL
messages.
•
See path ds1 fdl transmit.
Disabling Interfaces and Channel Groups
To disable interfaces and channel groups, use the following commands.
path ds1|e1 shutdown
•
Use to disable a T1 or an E1 interface.
•
T1 and E1 interfaces are enabled by default.
•
Example
host1 (config-controll)# path 12 e1 1/4/1 shutdown
125 Copyright © 2010, Juniper Networks, Inc.
Chapter 4: Configuring Channelized OCx/STMx Interfaces