Juniper JUNOSE 11.2.X MULTICAST ROUTING, Configuration Manual

Page: 173 / 256

•
alarms used for operational status calculation—Types of defects that the router
uses to determine the operational status of the interface at the path layer
•
defect trigger soaking delay—Time that the router waits to set an alarm when the
router records a defect at the path layer
•
c2 byte—Setting of path signal byte: set by upper interface type (automatic setting)
or configured value
•
Operational Status—Physical state of this layer: up, down, or lowerLayerDown
•
time since last status change—Time since the line module was rebooted
•
Framing—Type of framing configured for the controller:
•
c-bit parity framing (for T3 interfaces)
•
M23 multiplexer framing (for T3 interfaces)
•
crc4—Cyclic redundancy check (for E1 interfaces)
•
no-crc4—No cyclic redundancy check (for E1 interfaces)
•
esf—Extended superframe (for T1 interfaces)
•
sf—Superframe (for T1 interfaces)
•
Line Code—Type of line coding the router assigned to the controller: B8ZS or AMI
•
Clock source—Type of clock source configured for the channel:
•
module—Internal clock is from the line module itself
•
chassis—Internal clock is from the configured router clock
•
J1 transmit trace message—Trace message sent to the remote device
•
J1 expected trace message—Trace message expected from the remote device
•
J1 received trace message—Trace message received from the remote device
•
Example 1
host1# show controllers sonet 3/0 configuration
oc12 3/0
non channelized
ifAdminStatus: up
description: link1
snmp trap link-status: enabled
alarms used for operational status calculation: LOS LOF AIS RDI
defect trigger soaking delay: 2500 milliseconds
Operational Status: up
time since last status change: 00:03:30
Loopback State: none
Mode: sonet
Timing source: internal module
Receive FIFO Overruns: 0, Reconfigurations: 0
151 Copyright © 2010, Juniper Networks, Inc.
Chapter 4: Configuring Channelized OCx/STMx Interfaces