Juniper JUNOSE 11.2.X MULTICAST ROUTING, Configuration Manual

Page: 80 / 256

•
Use to configure the HDLC idle character.
•
The idle character is sent between HDLC packets.
•
Specify one of the following idle characters:
•
flags— Sets the idle character to 0x7E
•
marks —Sets the idle character to 0xFF
•
Example
host1(config-if)# idle-character marks
•
Use the no version to restore the default value, 0x7E (flags).
•
See idle-character.
interface serial
Use to configure a serial interface in the slot/port format.
•
•
slot —Number of the slot in which the line module resides in the chassis
•
port —Number of the port on the I/O module
•
Example
host1(config)# interface serial 3/0
•
Use the no version to disable the interface.
•
See interface serial.
invert data
•
Use to enable data stream inversion for the interface.
•
Enable data stream inversion only if it is turned on at the other end of the line.
•
Example
host1(config-if)# invert data
•
Use the no version to disable the feature.
•
See invert data.
load-interval
•
Use to set the time interval at which the router calculates bit and packet rate counters.
•
Choose a multiple of 30 seconds, in the range 30–300 seconds.
•
Example
host1(config-if)# load-interval 90
•
Use the no version to restore the default value, 300 seconds.
•
See load-interval.
mru
Copyright © 2010, Juniper Networks, Inc. 58
JunosE 11.2.x Physical Layer Configuration Guide