Juniper JUNOSE 11.2.X MULTICAST ROUTING, Configuration Manual

Page: 81 / 256

•
Use to configure the MRU size for the interface.
•
Specify a value in the range 4–9996 bytes.
•
Coordinate this value with the network administrator on the other end of the line.
•
If you set this parameter to a different value for another protocol, such as IP, the router
uses the lower value. This could produce unexpected behavior in your network.
•
Example
host1(config-if)# mru 1500
•
Use the no version to restore the default, 1600 bytes.
•
See mru.
mtu
•
Use to configure the MTU size for the interface.
•
Specify a value in the range 4–9996 bytes.
•
Coordinate this value with the network administrator on the other end of the line.
•
If you set this parameter to a different value for another protocol, such as IP, the router
uses the lower value. This could produce unexpected behavior in your network.
•
Example
host1(config-if)# mtu 1500
•
Use the no version to restore the default, 1600 bytes.
•
See mtu.
serial description
•
Use to assign a text description or an alias to a serial HDLC interface.
•
You can use this command to help you identify the interface and keep track of interface
connections.
•
The description or alias can be a maximum of 80 characters.
•
Use the show interfaces serial command to display the text description.
•
Example
host1(config-if)# serial description boston09 hdlc channel
•
Use the no version to remove the text description or alias.
•
See serial description.
Configuration Examples
To configure a T3 interface, start at the Global Configuration mode, and issue the following
commands:
host1(config)# controller t3 0/1
59 Copyright © 2010, Juniper Networks, Inc.
Chapter 2: Configuring T3 and E3 Interfaces