Juniper JUNOSE 11.2.X MULTICAST ROUTING, Configuration Manual

Page: 32 / 256

•
Framing type, clock source, cable length, and the loopback method for each T3
controller
• Framing type and clock source for each T1 channel
•
Timeslot mapping and line speed for each fractional T1 channel
•
HDLC channel information, such as data inversion information, cyclic redundancy check
(CRC) type, idle character, maximum transmission unit (MTU), and maximum receive
unit (MRU)
Configuration Tasks
To configure a channelized T3 interface:
1.
Configure a T3 controller.
2.
(Optional) Configure MDL settings.
3.
(Optional) Configure other settings for the interface.
4.
Configure T1 channels and subchannels.
5.
Configure HDLC channels.
Configuring a T3 Controller
To configure a T3 controller:
1.
Access Controller Configuration mode by specifying the T3 controller.
host1(config)# controller t3 0/1
2.
Enable the T3 controller.
T3 controllers are disabled by default.
host1(config-controll)# no shutdown
controller t3
Use to specify a T3 controller in slot/port format.
•
•
slot— Number of the slot in which the line module resides in the chassis
•
port —Number of the port on the I/O module
•
Example
host1(config)# controller t3 0/1
•
There is no no version.
•
See controller t3.
shutdown
•
Use to disable a T3 controller.
•
The T3 interface is disabled by default.
Copyright © 2010, Juniper Networks, Inc. 10
JunosE 11.2.x Physical Layer Configuration Guide