Juniper JUNOSE 11.2.X MULTICAST ROUTING, Configuration Manual

Page: 38 / 256

•
Use to disable T1 channels or a subchannel.
•
To disable channels or a subchannel, specify one or more T1 channels or a subchannel
in
channel or channel/subchannel format.
•
channel —One or more T1 channels, or a range of channels in the range 1–28
•
subchannel —Subchannel from 1–24
•
The T1 interface is enabled by default.
•
Example
host1(config-controll)# t1 4-15,18,21,25-27 shutdown
•
Use the no version to restart a disabled interface.
•
See t1 shutdown.
t1 snmp trap link-status
•
Use to enable SNMP link status processing on T1 channels.
•
To enable or disable SNMP on an interface, specify T1 channels or subchannel in channel
or channel/subchannel format.
•
channel —One or more T1 channels, or a range of channels in the range 1–28
•
subchannel —Subchannel from 1–24
•
Example
host1(config-controll)# t1 2 snmp trap link-status
•
Use the no version to disable SNMP link status processing.
•
See t1 snmp trap link-status.
t1 timeslots
•
Use to assign a range of DS0 timeslots to a subchannel as a single data stream.
•
To configure a subchannel, specify a T1 channel in channel/subchannel format and a
range of timeslots.
•
channel —T1 channel in the range 1–28
•
subchannel —Number from 1–24
•
dash—Represents a range of timeslots; a comma separates timeslots. For example,
1-10, 15-18 assigns timeslots 1–10 and 15–18.
•
Example
host1(config-controll)# t1 2/1 timeslots 1,3-8,10
•
You can specify a line speed that applies to all DS0 timeslots assigned to a subchannel.
The default line speed is 64 Kbps.
•
Use the no version to delete the fractional T1 circuit.
•
See t1 timeslots.
Copyright © 2010, Juniper Networks, Inc. 16
JunosE 11.2.x Physical Layer Configuration Guide