Juniper JUNOSE 11.2.X MULTICAST ROUTING, Configuration Manual

Page: 157 / 256

•
Use the no version to restore the default, 16.
•
See crc.
idle-character
•
Use to configure the HDLC idle character.
•
The idle character is sent between HDLC packets.
•
Specify one of the following idle characters:
•
flags —Sets the idle character to 0x7E
•
marks —Sets the idle character to 0xFF
•
Example
host1(config-ifs)# idle-character marks
•
Use the no version to restore the default value, 0x7E (flags).
•
See idle-character.
interface serial
•
Use to specify a serial interface.
•
Example for unframed E1 interface
host1(config)# interface serial 4/0:1/1/1/1/1
•
Example for fractional T1/E1 interface
host1(config)# interface serial 4/0:1/1/1/1/1
•
Example for unchannelized T3 interface
host1(config)# interface serial 4/0:1/1
•
Example for T3 interface channelized to fractional T1
host1(config)# interface serial 4/0:1/1/10/22
•
Use the no version to remove the interface.
•
See interface serial.
invert data
•
Use to enable data stream inversion for the interface.
•
Enable data stream inversion only if it is turned on at the other end of the line.
•
Example
host1(config-if)# invert data
•
Use the no version to disable the feature.
•
See invert data.
mru
135 Copyright © 2010, Juniper Networks, Inc.
Chapter 4: Configuring Channelized OCx/STMx Interfaces