Juniper JUNOSE 11.2.X MULTICAST ROUTING, Configuration Manual

Page: 150 / 256

•
Example
host1(config-controll)# path 12 ds3 1 framing m23
•
Use the no version to restore the default value, c-bit parity framing.
•
See path ds3 framing.
path ds3 shutdown
•
Use to disable a T3 interface.
•
T3 interfaces are enabled by default.
•
Example
host1(config-controll)# path 12 ds3 1 shutdown
•
Use the no version to restart a disabled interface.
•
See path ds3 shutdown.
path ds3 snmp trap link-status
•
Use to enable SNMP link status processing for a T3 interface.
•
The default disables SNMP link status processing.
•
Example
host1(config-controll)# path 12 ds3 1 snmp trap link-status
•
Use the no version to disable SNMP link status processing.
•
See path ds3 snmp trap link-status.
Configuring T3 Interfaces to Send MDL Messages
You can configure a T3 interface to send MDL messages. MDL messages are supported
only when the T3 framing is set for C-bit parity, the default setting.
To configure a T3 interface to send MDL messages:
1.
Specify a SONET interface.
host1(config)# controller sonet 8/0
2.
(Optional) Configure the interface to operate in an MDL carrier environment.
host1(config-controll)# path 12 ds3 1 mdl carrier
3.
Specify the MDL messages.
host1(config-controll)# path 12 ds3 1 mdl string eic "ERX1410"
host1(config-controll)# path 12 ds3 1 mdl string fic "FG786"
host1(config-controll)# path 12 ds3 1 mdl string lic "Bldg 2"
host1(config-controll)# path 12 ds3 1 mdl string pfi "Site 1"
host1(config-controll)# path 12 ds3 1 mdl string port 0800
host1(config-controll)# path 12 ds3 1 mdl string unit 080001
4.
Enable transmissions of MDL messages.
host1(config-controll)# path 12 ds3 1 mdl transmit path-id
Copyright © 2010, Juniper Networks, Inc. 128
JunosE 11.2.x Physical Layer Configuration Guide