Juniper JUNOSE 11.2.X MULTICAST ROUTING, Configuration Manual

Page: 140 / 256

path shutdown
•
Use to disable a specified path.
•
Paths are enabled by default.
•
Example
host1(config-controll)# path 2 shutdown
•
Use the no version to restart a disabled path.
•
See path shutdown.
path snmp trap link-status
•
Use to enable SNMP link status processing for the path layer of the interface.
•
The default is disabled.
•
Example
host1(config-controll)# path 2 snmp trap link-status
•
Use the no version to disable SNMP link status processing.
•
See path snmp trap link-status.
path trigger alarm prdi
•
Use to configure the router to use remote defect indications (RDIs) at the path layer
to determine the operational status of a path.
•
Example
host1(config-controll)# path 2 trigger alarm prdi
•
Use the no version to restore the default setting, in which the software uses loss of
pointer and AIS defects at the path layer to determine the operational status of a path.
•
See path trigger alarm prdi.
path trigger delay
•
Use to set the time duration after which the router sets an alarm when it records a
defect at the path layer.
•
Change this value from the default only when you are using MPLS fast reroute over a
SONET/SDH interface.
•
Specify a value of 0 milliseconds if this interface does not use APS/MSP or if MPLS
should have priority over APS/MSP.
•
Specify a value of at least 100 milliseconds if this interface uses APS/MSP and if
APS/MSP should have priority over MPLS.
•
Example
host1(config-controll)# path 2 trigger delay msec 1000
•
Use the no version to restore the default setting, 2500 milliseconds.
•
See path trigger delay.
Copyright © 2010, Juniper Networks, Inc. 118
JunosE 11.2.x Physical Layer Configuration Guide