Juniper JUNOSE 11.2.X MULTICAST ROUTING, Configuration Manual

Page: 113 / 256

•
Use the no version to restore the default, 5 (for sd-ber ) or 3 (for sf-ber ), for the specified
alarm.
•
See threshold.
Configuration Example
The following example shows how to configure working and protect interfaces for
APS/MSP.
1.
Configure the working interface.
host1(config)# controller sonet 3/0
host1(config-controller)# aps group boston
host1(config-controller)# aps working 1
2.
Configure the protect interface.
host1(config-controller)# controller sonet 3/1
host1(config-controller)# aps group boston
host1(config-controller)# aps protect 0
host1(config-controller)# aps unidirectional
host1(config-controller)# aps revert 30
host1(config-controller)# threshold sf-ber 4
Configuring APS Event Collection
To configure line modules to deliver APS events to the necessary SNMP traps, issue the
aps events command from Global Configuration mode.
aps events
•
Use to enable line modules to deliver APS events to the necessary SNMP traps.
•
Use the list variable to deliver the following types of APS events:
•
all—Configure notification of all APS events
•
channel-mismatch—Configure notification of APS channel mismatches
•
feplf—Configure notification of APS far-end protection line failures
•
mode-mismatch—Configure notification of APS mode mismatches
•
psbf—Configure notification of APS protection signal byte failures
•
switchover—Configure notification of APS switchovers
•
Example
host1(config)# aps events channel-mismatch
•
Use the no version to disable the delivery of APS events from line modules to SNMP
traps.
•
See aps events.
91 Copyright © 2010, Juniper Networks, Inc.
Chapter 3: Configuring Unchannelized OCx/STMx Interfaces