Juniper JUNOSE 11.2.X MULTICAST ROUTING, Configuration Manual

Page: 223 / 256

•
RX Input Power—Received input optical power
•
MTU—Size of the MTU for this interface
•
Operational—Size of the largest packet processed
•
Administrative—Setting for MTU size that you specified
•
Duplex Mode—Duplex option for this interface
•
Operational—Duplex option currently used
•
Administrative—Setting for duplex that you specified
•
Speed—Line speed for this interface
•
Operational—Current rate at which packets are processed
•
Administrative—Setting for line speed that you specified
•
Debounce—Debounce configuration for this interface
•
State is—Enabled, Disabled
•
Interval is—Number of seconds that this interface maintains a given state before
the state change is reported to the upper-layer links
•
Clear arp—State of the removal of the ARP entries on an interface with redundant
ports
•
Enabled—Clears ARP entries on the interface when the primary link fails
•
Disabled—Maintains ARP entries on the interface until the specified timeout elapses
•
Link —Link information for this interface
•
Operational Link Selected—Port that the I/O module is currently using: primary or
secondary
•
Administrative link selected—Port that the I/O module is configured to use:
•
primary—Only primary port is configured to operate
•
secondary—Only redundant port is configured to operate
•
automatically—Software controls port redundancy automatically
•
Link Failover Timeout — Time to wait for a failed link to be active before the router
uses a different active link
•
Primary link selected x times—Number of times that the I/O has used the primary
port since the module was last rebooted
•
Secondary link selected x times—Number of times that the I/O has used the
secondary port since the module was last rebooted
201 Copyright © 2010, Juniper Networks, Inc.
Chapter 5: Configuring Ethernet Interfaces