Juniper JUNOSE 11.2.X MULTICAST ROUTING, Configuration Manual

Page: 154 / 256

•
Use the no version to disable SNMP link status processing for a T1 channel.
•
See path ds3 snmp trap link-status.
path ds3 t1 timeslots
•
Use to assign a range of DS0 timeslots to a subchannel as a single data stream.
•
You can specify a line speed for all DS0 timeslots assigned to a subchannel.
•
Examples
host1(config-controll)# path 2 ds3 1 t1 28 timeslots 1-10
host1(config-controll)# path 2 ds3 1 t1 28/1 timeslots 1-10 speed 56
•
Use the no version to delete the fractional T1 circuit.
•
See path ds3 t1 timeslots.
Configuring T1 Channels to Send FDL Messages
To configure T1 channels to send FDL messages:
1.
Specify a SONET interface.
host1(config)# controller sonet 8/0
2.
Specify the standard for transmission of FDL messages on both ends of the T1
connection.
host1(config-controll)# path 2 ds3 1 t1 28 fdl ansi
3.
(Optional) Configure the interface to operate in an FDL carrier environment.
host1(config-controll)# path 2 ds3 1 t1 28 fdl carrier
4.
(ANSI signals) Specify the FDL messages.
host1(config-controll)# path 2 ds3 1 t1 28 fdl string eic "ERX1410"
host1(config-controll)# path 2 ds3 1 t1 28 fdl string lic "Bldg 10"
host1(config-controll)# path 2 ds3 1 t1 28 fdl string fic "GY788"
host1(config-controll)# path 2 ds3 1 t1 28 fdl string unit 080001
5.
Enable transmission of FDL messages.
host1(config-controll)# path 2 ds3 1 t1 28 fdl transmit idle-signal
path ds3 t1 fdl
•
Use to specify the FDL standard for the interface.
•
Specify the T1 channels in the range 1 through 28.
•
Specify the keyword ansi to support the ANSI FDL standard (see “References” on
page 113).
•
Specify the keyword att to support the AT&T FDL standard (see “References” on
page 113).
•
Specify the keyword all to support both the ANSI and AT&T standards
•
Specify the keyword none to remove the current FDL mode settings
Copyright © 2010, Juniper Networks, Inc. 132
JunosE 11.2.x Physical Layer Configuration Guide