Juniper JUNOSE 11.2.X MULTICAST ROUTING, Configuration Manual

Page: 33 / 256

•
Example
host1(config-controll)# no shutdown
•
Use the no version to restart a disabled interface.
•
See shutdown.
Configuring MDL Messages
You can configure a channelized T3 interface to send MDL messages. MDL messages
are supported only when T3 framing uses C-bit parity, the default setting.
To configure a channelized T3 interface to send MDL messages:
1.
Specify a T3 interface.
host1(config)# controller t3 8/0
2.
(Optional) Configure the interface to operate in an MDL carrier environment.
host1(config-controll)# mdl carrier
3.
Specify the MDL messages.
host1(config-controll)# mdl string eic "ERX1410"
host1(config-controll)# mdl string fic "FG786"
host1(config-controll)# mdl string lic "Bldg 10"
host1(config-controll)# mdl string pfi "Site 25"
host1(config-controll)# mdl string port 0800
host1(config-controll)# mdl string unit 080001
4.
Enable transmission of MDL messages.
host1(config-controll)# mdl transmit path-id
host1(config-controll)# mdl transmit idle-signal
host1(config-controll)# mdl transmit test-signal
mdl carrier
•
Use to specify that an interface is used in the carrier environment.
•
Example
host1(config-controll)# mdl carrier
•
Use the no version to restore the default situation, in which the interface does not
operate in the carrier environment.
•
See mdl carrier.
mdl string
•
Use to specify an MDL message.
•
Example
host1(config-controll)# mdl string port 0800
•
Use the no version to restore the default value to the specified MDL message or to all
MDL messages.
•
See mdl string.
11 Copyright © 2010, Juniper Networks, Inc.
Chapter 1: Configuring Channelized T3 Interfaces