Juniper JUNOSE 11.2.X MULTICAST ROUTING, Configuration Manual

Page: 244 / 256

•
Use the optional config keyword to display information about available and provisioned
tunnel-service interfaces on each port, and to indicate whether modules that support
the use of dedicated or shared tunnel-server ports are currently installed in the router.
•
Field descriptions
•
Port:Appl—Identifier in slot / port or slot/adapter/port format for the module or
tunneling application
•
slot—Number of the slot in the chassis where the module resides
•
adapter—Number of the bay in which the I/O adapter (IOA) resides.
This identifier applies only to dedicated and shared tunnel-server ports configured
on the E120 and E320 routers. Dedicated tunnel-server ports are always adapter
0; shared tunnel-server ports are always adapter 2.
•
port —Number of the tunnel-server port on the module; for dedicated tunnel-server
ports, this is a virtual port number that is always 0; for shared tunnel-server ports,
this is a virtual port number dynamically assigned by the router
•
Card Type or Active Type—Type of port: dedicated or shared
•
Oper State or Max State—Physical state of the port or application
•
up—Port or application is available
•
down—Port or application is unavailable
•
present—Module associated with this port is installed
•
not present—Module associated with this port has been removed
•
pending—Router has not yet detected all previously configured modules during a
reboot or initial installation of the module
•
Active Interfaces or Interfaces—Number of tunnel-service interfaces currently
configured on this port
•
Max Interfaces—Total number of tunnel-service interfaces available on this module
•
Fill—Percentage of available interfaces used by a server port, an application on a
server port, an application on all server ports, and all server ports
•
Appl Totals—Statistics for each application
•
Server Ports—Displays configuration information about dedicated and shared
tunnel-server ports on the router; this display format appears only when the
config
keyword is specified
•
Port—Identifier in slot / port format (ERX7xx models, ERX14xx models, and ERX310
routers) or s lot/adapter/port format (E120 and E320 routers) for the module on
which the tunnel-server port resides
•
Type—Type of tunnel-server port: dedicated or shared
Copyright © 2010, Juniper Networks, Inc. 222
JunosE 11.2.x Physical Layer Configuration Guide