Juniper JUNOSE 11.2.X MULTICAST ROUTING, Configuration Manual

Page: 78 / 256

To configure fractional T3:
1.
Set the DSU mode for the lines.
2.
Set the speed of the fractional T3 lines.
3.
Enable scrambling of the payload.
CAUTION: Complete all three steps at the same time. Otherwise, the interface might
drop packets unexpectedly.
dsu bandwidth
•
Use to set the speed for the fractional T3 lines.
•
If you issue this command, be sure to issue the dsu mode and scramble commands.
Otherwise, the interface might drop packets unexpectedly.
•
The router offers a set of speeds in increments that depend on the DSU mode you
specify. The actual speed of the fractional T3 lines will be the value closest to the
fractional bandwidth you specify.
•
Example
host1(config-controll)# dsu bandwidth 10000
•
Use the no version to clear the bandwidth.
•
If you issue the no version, be sure to issue the no dsu mode and no scramble
commands. Otherwise, the interface might drop packets unexpectedly.
•
See dsu bandwidth.
dsu mode
•
Use to set the DSU mode for the lines.
•
Specify 0 for Digital Link mode or 2 for Larscom mode.
•
If you issue this command, be sure to issue the dsu bandwidth and scramble
commands. Otherwise, the interface might drop packets unexpectedly.
•
Example
host1(config-controll)# dsu mode 0
•
Use the no version to clear the DSU mode.
•
If you issue the no version, be sure to issue the no dsu bandwidth and no scramble
commands. Otherwise, the interface might drop packets unexpectedly.
•
See dsu mode.
scramble
•
Use to enable cell scrambling on a T3 frame interface.
•
If you issue this command, be sure to issue the dsu mode and dsu bandwidth
commands. Otherwise, the interface might drop packets unexpectedly.
Copyright © 2010, Juniper Networks, Inc. 56
JunosE 11.2.x Physical Layer Configuration Guide