7-3
Introduction
This chapter tells you how to do the usual maintenance and calibration tasks necessary to
keep the 5502A Calibrator in service.
See the Service Manual for intensive maintenance tasks like troubleshooting, calibration
or repair, and all procedures where it is necessary to open the Calibrator cover. The
Service Manual also has complete verification and calibration procedures.
Warning
To prevent possible electrical shock, fire, or personal injury:
•
Turn the Product off and remove the mains power cord.
Stop for two minutes to let the power assemblies discharge
before you open the fuse door.
•
Replace a blown fuse with exact replacement only for
continued protection against arc flash.
•
Disconnect the mains power cord before you remove the
Product covers.
•
Use only specified replacement parts.
•
Use only specified replacement fuses.
•
Have an approved technician repair the Product.
Replace the Mains Power Fuse
Warning
To prevent possible electrical shock, fire, or personal injury, replace a
blown fuse with exact replacement only for continued protection against
arc flash.
Access the line-power fuse on the rear panel. The fuse rating is 5 A/250 V slow blow fuse
when the Calibrator is set to 100 V/120 V line voltage, 2.5 A/250 V slow blow when the
Calibrator is set to 220 V/240 V line voltage. Fuses that are not user replaceable are
shown in the “Maintenance” section of Chapter 7.
To examine or replace the fuse, see Figure 7-1 and continue as follows:
1.
Disconnect line power
.
2.
Open the fuse compartment. Put a screwdriver blade into tab on the left side of the
compartment and carefully pry until it can be removed with the fingers.
3.
Remove the fuse from the compartment for replacement or verification. Be sure the
correct fuse is installed.
4.
Put the fuse compartment into the Calibrator. Push it into position until the tab locks.
Summary of Contents for 5502A
