5502A
Operators Manual
4-32
Caution
To prevent damage to the UUT, make sure the applied voltage
to the UUT is not larger than the rating of the UUT insulation
and the connection wires.
2.
Push
to clear any output from the Calibrator.
3.
Connect the UUT as in the “Connect the Calibrator to a UUT” section of this chapter.
4.
Set the UUT to measure dual ac voltage on the necessary range.
5.
Push the numeric keys and decimal point key to record the necessary voltage output
at the NORMAL terminals (maximum six numeric keys). For example, 123.456.
6.
Push a multiplier key, if necessary. For example, push
.
7.
Push
.
8.
The Control Display shows the amplitude of your voltage entry. For example,
123.456 mV (see below).
nn084f.eps
Note
The AUX output is 3.3 V rms maximum for sine waves, 6.6 V p-p for square
waves, 9.3 V p-p for triangle and truncated sine waves.
9.
Push the numeric keys and decimal point key to record the necessary voltage output
at the AUX terminals (maximum six numeric keys). For example, 234.567.
10.
Push a multiplier key, if necessary. For example, push
.
11.
Push
.
12.
The Control Display shows the amplitude of your entries for the NORMAL terminals
(upper reading) and AUX terminals (lower reading) (below is typical).
nn092f.eps
13.
Push the numeric keys and decimal point key to record the necessary frequency
output (maximum five numeric keys). Push a multiplier key, if necessary. For
example, push the kilo multiplier key
. Then push the
key. For example,
1.1234 kHz.
Summary of Contents for 5502A
