5502A
Operators Manual
4-64
Table 4-5. Harmonics Performance for Volts, Harmonics Screen
5502A
Normal Output
Fluke
Tester
Performance Limits
Amplitude Harmonic Phase
Harmonic
cursor
Amplitude Phase
(V) No.
(deg.)
No. MIN
MAX
MIN
MAX
7.00 1 -10 1 6.7 7.3 8 12
7.00 3 -20 3 6.7 7.3
14 26
7.00 9 -30 9 6.7 7.3
21 39
7.00 13 -40 13 6.7 7.3 29 51
7.00 21 -50 21 6.5 7.5 35 65
7.00 31 -60 31 6.2 7.8 40 80
11.
Push
to remove the voltage from the Tester.
Verify Harmonics Amps Performance
1.
Push the VAW button on the Tester until A is shown above the top right corner of the
harmonics display.
2.
Push the VA
φ
REF button on the Tester until V
φ
is shown in the top status line.
3.
Push the SMOOTH button on the Tester until ~20s is shown in the top status line of
the Tester.
4.
Connect the Calibrator NORMAL output to the V and COM connectors on the
Tester.
5.
Connect the Calibrator AUX output to the Current Probe connector on the Tester.
6.
Set the Calibrator output to 7.0 V at 60 Hz on the NORMAL output and 20 mV at
60 Hz on the AUX output. Push the WAVE MENUS, then the
φ
& REF MENUS
softkey and make sure the phase angle is 10.00 degrees. Push the HARMONIC
MENU softkey and make sure the HARMONIC selection is set to “1” and the
FUNDMTL selection is set to “normal.” Push
.
7.
See that the harmonic amplitude and phase angle indications shown by the Tester are
in the minimum and maximum limits shown in Table 4-6.
Summary of Contents for 5502A
