100/180 mm PAPERLESS GRAPHIC RECORDER: USER GUIDE
User Guide
Page 207
HA028910
Issue 13 Sep 16
4.4.2 MANAGEMENT (Cont.)
CONFIGURABLE PARAMETERS (Cont.)
Notes:
1. The Confi guration Revision (and for changes in the Security menus - the Security Revision) are
incremented every time the recorder confi guration (security confi guration) is changed. The
current values can be viewed in the System/About menu (
section 4.6.11
).
2. All confi guration and security changes must be made either at the recorder operator interface,
or from a host pc using Bridge ‘Full’ software. Use of the confi guration editor is not permitted if
traceability is to be maintained.
3. If fi tted, Event buttons (
section 4.3.7
) are not included in the Require Signing/Require Authori-
zation regime described above. Instead, each individual button can be confi gured to require
signing or to require both signing and authorization.
4. If a large number of confi guration changes are made with Audit trail enabled, then the number
of messages produced may result in the total amount of data generated exceeding the amount
that can be written to the internal FLASH memory in the time available, particularly if there are
a large number of points confi gured. The recorder responds by reducing the recording speed,
and a message ‘ Recording failed - internal overfl ow. Slowing recording interval of fastest
group(s)’ appears, to draw the user’s attention to the situation.
5. If the TUS option is enabled, then enabling Audit trail can causes pre calibration and post
calibration values to be printed for each adjusted channel, before a batch initiation and/or after
a batch stop according to the confi guration of the ‘Pre calibration’ and ‘Post calibration’ tick
boxes in the Batch Confi guration menu.
Password Change on Expiry
If this check box is enabled, then the fi rst time a user tries to login, after his or her
password has expired, a dialogue box appears asking the user to enter a new pass-
word. Only when this new password has been entered and confi rmed, will the user
be able to access the recorder confi guration.
Security Management Option. The new password is not written to the Security
Manager until the next ‘deploy’, after which the expiry period confi gured for the user
(within Security Management), is restored. The interim expiry period is set to 24
hours, and the ‘deploy’ must be carried out within this period, or password expiry
will recur.
Change Password
New Password
Retype Password
Apply
Logout
Centralised Security This checkbox occurs only if the Security Management option is fi tted.
If this checkbox is enabled, none of the other parameters in the Management menu
can be edited at the recorder (i.e. they become ‘Read Only’). Changes can be made
only by means of Security Management software. At the recorder, the menu items
below also become ‘read only’, or do not appear as menu items or are not selectable,
even if the checkbox appears:
Access level permissions (
section 4.1.1
) (Read Only)
Add User
/
Remove User
(section 4.4.3/4) (Do not appear as menu items)
Restore confi guration/Security data (
section 4.2.2
) (Not selectable)
New confi guration/Security data (
section 4.2.3
) (Not selectable)
(Continued...)
