100/180 mm PAPERLESS GRAPHIC RECORDER: USER GUIDE
HA028910
Issue 13 Sep 16
User Guide
Page 148
4.3.14 TIMERS (Cont.)
CONFIGURABLE PARAMETERS
Timer number
Allows a specifi c timer to be selected for confi guration
Enable
Allows the user to enable/disable the selected timer
Remaining
This is a dynamic display showing the time remaining in hours:minutes:seconds for-
mat.
Repeat in
For repeat timers, shows the time remaining before the repeat is initiated. Display is
00:00:00 whilst timer is counting down.
Reset now
Allows a running timer to be reset to 00:00:00.
Start now
Allows the operator to initiate the timer.
Descriptor
Allows a descriptor to be entered for the timer.
Self Start
If enabled, this causes date and time selection fi elds to appear as shown in fi gure
4.3.14 above.
Date:
allows a day number to be selected from a picklist of 1 to N and ‘Any’,
where N is the maximum number of days in the selected month.
Month:
allows a month number to be entered from a picklist of 1 to 12 and ‘Any’.
Hour:
allows an hour number to be selected from a picklist of 1 to 23, ‘Midnight’
and ‘Any’.
Minute:
allows a minutes number to be entered from a picklist of 0 to 59 and ‘Any’.
Seconds: allows a seconds value to be entered from a picklist of 0 to 59 and ‘Any’.
Duration
Allows the user to enter a count-down time period in seconds.
Repeat after
Allows the user to enter a repeat rate. It should be noted that the repeat value
includes the duration time. For example, to time down from 50 seconds, every
minute, a ‘Duration’ value of 50 seconds should be entered, with a ‘Repeat after’
value of 60 seconds (not 10 seconds).
Note: If Month = ‘Any’, and Day = 31, then the timer will not be triggered in February, April, June,
September or November. Similarly, if Day = 30, the timer will not be triggered in February, and so
on.
Job confi guration is as described in
section 4.7
.
SELF-START EXAMPLE
To preset Totaliser number 1 to zero, daily, at midnight:
In totaliser confi guration, enter 0 as the Preset value for Totaliser 1.
In timer confi guration, select:
1. Timer number Timer 1
2. Enable
enabled
3 Self start
enabled
4 Date
Any
5. Month
Any
6. Hour
Midnight
7. Minute
0
8. Second
0
9. Duration
0.125
10. Repeat after
0
11. Job number
1
12. Job category Totaliser
13. Action
Preset
14. Totaliser
Totaliser 1
15. On
Active