Aquastorm 200
4-44 Maintenance
Optional Adjustable Inlet Conveyor
Optional Exit End Conveyor Extension
Check Belt Tension Here or Here
3.3
CONVEYOR WIRE BELT
TENSION ADJUSTMENT
1
Press the
Power Off Control to disable
system power.
2
Place the index finger of each hand behind
the belt at a point midway in the vertical
travel of the wire belt. This can be done at
either the entrance or exit end of the
conveyor.
3
Pull outward with moderate force.
The belt should not extend more than 3.8
cm (1
1
/
2
in.) from its relaxed state.
4
If belt slack is excessive, remove links as
necessary by bending the “U” at each side
of the link and weaving the link out of the
wire belt.
Remove as many links as necessary to
obtain the correct wire belt tension.
Follow the Wire Belt Connecting Link
Replacement Procedure in this section
of the manual to reconnect the wire belt.
5
Recheck the wire belt for correct tension.
Summary of Contents for Aquastrom 200
Page 48: ......
Page 142: ...Aquastorm 200 Maintenance 4 49 ...
