Aquastorm 200
Maintenance 4-47
5
When the loop end of the splicing link is
properly inserted, the loop end of the splicing
link extends below the wire belt as depicted in
photograph 5.
Using a small flat head screwdriver,
as shown in photograph 6, insert the
screwdriver under the wire belt link,
opposite the side already looped and
insert the tip of the screwdriver into
the splicing link loop, applying a
downward pressure on the loop by
pulling upwards on the screwdriver
handle.
The loop end of the Splicing
Link extends below the wire
belt when properly inserted
6
Insert screwdriver here
Insert tip of screwdriver in
the Splicing Link Loop
Pull up on screwdriver handle
To complete the splice on one (1)
end of the splicing link, while still
applying pressure on the handle of
the screwdriver with the tip of the
screwdriver inserted in the link's loop,
force the handle of the screwdriver
over in the opposite direction to force
the open end of the loop on the
splicing link to catch the wire belt link
that the screwdriver was inserted
through in photograph 6.
Repeat the steps outlined in
photographs 4 thru 7 to connect the
opposite end of the splicing link and
both ends of the remaining splicing
link.
Force handle of screwdriver in
this direction leaving the tip of
the screwdriver inserted in the
loop of the link
Force the open end of the link's loop
to catch the wire belt link here
7
Summary of Contents for Aquastrom 200
Page 48: ......
Page 142: ...Aquastorm 200 Maintenance 4 49 ...
