Chapter 8 Parameters
ASDA-A2R Series
Revision December, 2014
8-193
Failure code
F067h
Data calculation error. Please decrease the setting
value of (P1-44,P1-45) and keep the proportion will do.
Command
code 0007h
Create E-Cam table: Flying cut
General
parameters
P5-81 = Address of table (data array)
P5-82 = N (30~72) (Area number of E-Cam)
P1-44, P1-45 = E-gear ration (has to be setup first)
Macro
parameters
P5-93.H16 (high 16-bit) = S
P5-93.L16 (low 16-bit) = W
Among them:
S (curve level) = 1~4 levels
W (degree of waiting area) = -1~170 degrees
W = -1 is available in firmware version V1.038 (sub29)
(or the later version)
P5-94 = Y (degree of synchronous area) = 0~330 degrees
P5-95.H16 (high 16-bit) = A x C
P5-95.L16 (low 16-bit) = B
Among them:
A (Deceleration ratio: numerator), C (Number of cutter)
B (Deceleration ratio: denominator)
P5-96 = 1000000 x R x V
Among them:
R (cutting ratio)
= L (target cutting length)
／
ℓ
(Length of cutter)
Allowable cutting ratio: (0.05 ~ 5.0) times
V (speed factor) = target cutting speed
／
speed of
delivered product
V=1.0: When cutting, the speed of cutter is the same as the
product
V=1.1: When cutting, the speed of cutter is 10% faster than
the product
V=0.9: When cutting, the speed of cutter is 10% slower than
the product
