DATREND Systems ES601-US, Operating Manual

Page: 123 / 244

ES601-US OPERATING MANUAL
Automated Testing/Chapter 6
#
Page 103
Figure 70 - Safety AutoSequence in progress.
The NEXT button of the Sequence Controls menu launches the safety test. As the test sequence progresses,
the display of ES601-US provides user prompts and instructions as necessary, and reflects real-time
information about the tests performed. This includes the type of test currently being executed within the
sequence (line voltage, ground, leakage current, etc.), the safety standard used, AC supply status, the
measured value(s), the pass/fail limits, and the pass/fail assessment of the measurement result. Throughout
the test sequence,
PAUSE , ESCAPE , REPEAT and CONTINUE buttons are available as applicable to
the test being performed. The functions of these keys are described in Chapter 5.
Depending on "STOP AFTER..." and "STOP BEFORE..." settings of the Sequence Control setup, ES601-
US may stop at selected steps in the test sequence and prompt you to operate the power switch of the DUT.
These "BREAK" prompts are described in Section 5.10.
The order of measurements in the sequence is set by ES601-US, but the enabling of the measurements is
defined by the user through the AutoSequence programming. The table below lists the order of the
measurements and the corresponding status of the AC supply to the DUT.