Canon Vizcam 1000, Service Manual

Page: 304 / 840

4. MECHANICAL SYSTEM
4-50
COPYRIGHT © 2001 CANON INC. CANON CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
5. Removing the Transfer Belt Swing
Motor (M13)
1) Slide out the transfer unit assembly toward the
front, and open the transfer belt assembly
(See chapter 4. IV. Transfer Unit, A-2.
Opening the Transfer Belt Assembly).
2) Remove the screw [1], and disconnect the
connector [2]; then, remove the belt swing
motor [3].
3) Remove the screw [1], and disconnect the
connector [2]; then, remove the belt swing
motor [3].
Figure 4-429A
6. Removing the Transfer Belt
Assembly
1) Open the front cover, and slide out the transfer
unit assembly to the front.
2) Open the transfer belt assembly (See chapter
4. IV. Transfer Unit, A-2. Opening the Transfer
Belt Assembly).
3) Remove the three screws [3], and remove the
transfer frame front support plate [4].
If you have removed or replaced the
transfer belt motor, be sure to initial-
ize the transfer belt drive data using
‘FUNC > F-MISCp > E075-RLS’.
(See chapter 7. Initializing the Trans-
fer Belt Swing Control Data.)
[2]
[1]
[3]
Figure 4-430A
4) Remove the transfer belt assembly [5] by
moving it in the direction of the arrow.
Figure 4-431A
[4]
[3]
[3]
[5]