Canon Vizcam 1000, Service Manual

Page: 305 / 840

COPYRIGHT © 2001 CANON INC. CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
4-51
4. MECHANICAL SYSTEM
7. Removing the Transfer Belt Motor
(M14)
1) Slide out the transfer unit assembly toward
the front, and open the transfer belt assembly
(See chapter 4. IV. Transfer Unit, A-2.
Opening the Transfer Belt Assembly).
2) Disconnect the connector [1], and remove the
three screws [2] and the adjusting screw [3];
then, remove the transfer belt motor [4].
9. Removing the Internal Static
Eliminating Roller
1) Slide out the transfer unit assembly to the
front.
2) Remove the transfer front cover (See chapter
4. IV. Transfer Unit, A-1a. Removing the
Transfer Blade).
3) Set the transfer releasing lever.
4) Remove the two screws [2], and remove the
transfer rear cover [1].
Figure 4-432A
8. Installing the Transfer Belt Motor
1) Install the transfer belt using the steps used to
remove it but only in reverse.
2) Install it so that the gap of the adjusting screw
[1] is 3.5 ±0.3 mm.
Figure 4-433A
[2]
[2]
[1]
[3]
[1]
3.5 ± 0.3mm
Figure 4-434A
5) Disconnect the connector [3].
Figure 4-435A
[2]
[2]
[1]
[3]
When installing the internal static
eliminating roller, check to make
sure that the connector [3] is se-
curely connected.