Canon Vizcam 1000, Service Manual

Page: 461 / 840

7-25
COPYRIGHT © 2001 CANON INC. CANON CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
7. TROUBLESHOOTING IMAGE FAULTS/MALFUNCTIONS
G. When Replacing the Pick-
Up/Feeding-Related Parts
1 Registering the Cassette/
Multifeeder Paper Width Basic
Setting (under ‘FUNC’)
You must register the paper width basic setting
if you have
• Replaced the paper width VR of the copier
(including the multifeeder).
• Adjusted the front/rear registration for the
cassette.
For the cassette, you must register the setting
for ‘STMTR’ and ‘A4R’; for the multifeeder, you
must register the setting for ‘A6R’, ‘A4R’, and ‘A4’.
a. Cassette 1 or 2
1) Slide out the cassette you want to register the
setting for, and set the paper width guide plate
inside the cassette to A4R.
2) Set the cassette in the copier.
3) Check that the basic setting is indicated on the
CST-AD screen of ‘FUNC’ in service mode on
the control panel.
4) Select the size of the cassette for which you
want to register the basic setting:
UP-A4R (cassette 1)
LOW-A4R (cassette 2)
5) Note that basic setting 1 has been registered.
6) Slide out the cassette you want to register the
setting for, and set the paper width guide plate
inside the cassette to STMTR.
7) Set the cassette in the copier.
8) Check that the basic setting is indicated on the
CST-AD screen of ‘FUNC’ in service mode on
the control panel.
9) Select the size of the cassette for which you
want to register the basic setting:
UP-STMTR
LOW-STMTR
10) Note that basic setting 2 has been registered.
b. Multifeeder
1) Set the paper guide plate of the multifeeder to
A4R (210 mm).
2) Note that the basic setting is indicated on the
CST-AD screen for ‘FUNC’ in service mode on
the control panel.
3) Select the size for which you want to register
the basic setting.
MF-A4R
4) Note that basic setting 1 has been registered.
5) Set the paper guide plate of the multifeeder to
A6R (105 mm).
105mm
Paper (A6R)
Guide (rear)
Guide (front)
Figure 7-242 (e.g., A6R)