Page 52 P/N: 4998152533-02
Copyright
2007 Bosch Security Systems, Inc.
DS7200V2-UK Installer's Guide
PART IV: CONTROL PANEL PROGRAMMING
Automatic Test {137} Report Interval
•
Address: 0254
•
Default: 3 (7 Days)
•
Selections:
−
0 = No Automatic Test
−
1 = 1 Hour
−
2 = 1 Day
−
3 = 7 Days
−
4 = 28 Days
Entering zero (0) at this parameter disables the Automatic Test {137} report.
The one-hour interval is incremented on the minute. For example, if you set the Automatic Test Time parameter to 1020 (10:20
am), the Automatic Test Interval is one hour, and left programming mode at 11:10, then the control panel sends a test report at
11:20 am (less than one hour after leaving programming mode). The next test report is sent at 12:20 pm.
The one-day, seven-day and 28-day intervals are incremented at midnight (2400). For example, if you set the Automatic Test
Time parameter to 1020 (10:20 am), the Automatic Test Interval is one day and left programming mode at 10:10 am, then the
control panel does not send a test report until 10:20 the next day (after the one-day interval increment at midnight).
If the Automatic Test report is disabled in the Automatic Test Report Options parameter (see page 51), this parameter is
meaningless.
Test Report Routing
•
Address: 0255
•
Default: 1 (Reports to Destination 1, Events to Log/Printer)
•
Selections:
−
0 = No Reports, no Events to Log/Printer
−
1 = Reports to Destination 1, Events to Log/Printer
−
2 = Reports to Destination 2, Events to Log/Printer
−
3 = Reports to Destinations 1 & 2, Events to Log/Printer
−
4 = Reports to Destination 2 only on Destination 1 Comm Fail Event, Events to Log/Printer
−
5 = No reports, Events to Log/Printer
This is a global (affects all areas) parameter.
Test reports include the System Test {137}/{138} reports. The Walk Test Start {158} and Walk Test End {159} reports follow
their own routing.
Reporting must be enabled at the Global Reporting Options parameter (see page 47) and at least one
phone number (or IP address) must be entered for one routing destination (see page 42).
