Page 2 P/N: 4998152533-02
Copyright
2007 Bosch Security Systems, Inc.
DS7200V2-UK Installer's Guide
Term
Silkscreen Label
Description
1,2
18 VAC
18 V, 50 VA; #18 AWG (1.2 mm), Stranded.
3
Earth Ground Symbol
Earth Ground.
4 Data,
Grn
(Green)
5 Data,
Yel
(Yellow)
Data Bus data on Terminals 4 & 5. Panel supports up to 305 m of #22 AWG (0.8 mm) wire on
these terminals (any configuration).
6,7
Aux Power 12 VDC (-)
8,9
Aux Power 12 VDC (+)
Terminals 6-9 are auxiliary power. 1.2 A. Include any programmable outputs (PO 1 to PO 4) not
configured for alarm output. PTC suppressed.
Aux/Data (RYGB)
4-pin connector to Data Bus and auxiliary power. Use to connect an installer keypad for keypad
programming.
Red (Batt +)
Battery (+) spade.
Black (Batt -)
Battery (-) spade.
10 PO
4
11 PO
3
Programmable Outputs 3 & 4, up to 500 mA (-). Include in Aux Power calculations for all except
“Alarm” output functions. PTC suppressed.
12
PO 2
Programmable Output 2. 500 mA (-).Include in Aux Power calculations for all except “Alarm”
output functions. Supervised for Horn/Speaker alarm function. PTC suppressed.
13
Alrm +
Alarm power. Up to 1,850 mA. PTC suppressed. Provides power for supervised siren driver (PO
2) and Alarm Output (PO 1, A).
14
PO 1, A
15
PO 1, B
Jumper sets PO 1 terminals A (14) and B (15) for “dry” Form “A” contact or for Alarm Output
(using PO 1, A as negative (-) terminal).
16
SMK +
Not used.
17
L-1
Sensor Loop 1. Wire length for Sensor Loops 1 to 8 are limited only by the resistance on the loop
and potential EMI problems. Resistance must be < 100
Ω
with EOL resistor shorted and detection
devices connected.
18
Com
Common for Sensor Loops 1 and 2.
19
L-2
Sensor Loop 2 input.
20 L-3
Sensor
Loop
3.
21
Com
Common for Sensor Loops 3 & 4.
22 L-4
Sensor
Loop
4.
23 L-5
Sensor
Loop
5.
24
Com
Common for Sensor Loops 5 & 6.
25 L-6
Sensor
Loop
6.
26 L-7
Sensor
Loop
7.
27
Com
Common for Sensor Loops 7 & 8.
28 L-8
Sensor
Loop
8.
29
T
Connections for incoming phone lines.
30
T1
Connections for premises devices such as telephones.
31
R1
Connections for premises devices such as telephones.
32
R
Connections for incoming phone lines.
PO 1 SELECT
Configures PO 1 for Form “A” relay or Alarm Output.
Auxiliary
Auxiliary
Module
and/or Programming Key (PK32) Header.
Table 1: Terminal Descriptions
