DS7200V2-UK Installer's Guide
Copyright
2007 Bosch Security Systems, Inc.
P/N: 4998152533-02 Page 19
PART II: SYSTEM INSTALLATION AND SETUP
Use the following steps to install a DX2013 in the
CX1011 Enclosure:
1. Insert the DX2013’s angle bracket hooks into the
mounting slots in the back wall of the CX1011
Enclosure. See Figure 18.
Hook
Slot
Screw Hole
Enclosure Back Wall
Back of DX2013
Mounting Plate
Back of
Angle Bracket
Figure 18: Mounting the DX2013 (Step 1)
2. Pull DX2013 down so that the angle bracket
hooks are flush in the mounting slots. See Figure
19.
Hooks flush
with Slots
Back of DX2013
Mounting Plate
Screw Hole
Enclosure Back Wall
Back of
Angle Bracket
Figure 19: Mounting the DX2013 (Step 2)
3. Secure the DX2013 to the CX1011 enclosure
wall with a mounting screw (provided with
DX2013). See Figure 20.
Enclosure Back Wall
Mounting Screw
Front of
Angle Bracket
Front of
DX2013
Figure 20: Mounting the DX2013 (Step 3)
18.3 DX2010
Wiring
Do not use twisted pair or shielded cable when
wiring the DX2010.
Refer to the following data bus wire length
requirements:
Power
Source
0.8 mm
(#22 AWG)
1.2 mm
(#18 AWG)
Aux Output
Not Used
305 m
(1007.7 ft.)
610 m
(2001 ft.)
Aux Output
Used
Control Panel
30 m
(98.4 ft.)
76 m
(249.3 ft.)
Aux Output
Used or Not
Used
External
Power
Supply
305 m
(1007.7 ft.)
610 m
(2001 ft.)
Table 5: DX2010 to Control Panel Wire Length
0.8 mm
(#22 AWG)
1.2 mm
(#18 AWG)
Aux Output
Not Used
305 m
(1007.7 ft.)
610 m
(2001 ft.)
Aux Output
Used
30 m
(98.4 ft.)
76 m
(249.3 ft.)
Table 6: DX2010 to External Power Supply Wire Length