Chapter 1
8
Scalar AIT 440/480
Tools required
You need the following tools to install the library into a rack:
Installing the slide rails in the rack
1.
Identify the holes on the rack where you want to install the library.
The library will extend 1 to 2 inches (3 to 4 cm) below the slide rails.
2.
If the rack does not have threaded holes, attach eight of the ten clip
nuts over the holes (see
Figure 1-2
).
3.
Using a T-25 TORX driver and eight 10-32
×
0.5 pan head screws,
attach, but do not tighten, the slide rails to the rack (see
Figure 1-2
).
Tools required for rack-mount installation
Included in the accessory box
Not included
S
Two slide rails
S
Eight 10-32
×
0.5 pan head screws
S
Two 10-32
×
1.0 pan head screws
S
Two 8-32
×
7/16 button head screws
S
Ten clip nuts
S
Standard 19-inch EIA rack, 30 to 36
inches deep, equipped with extension
support legs
S
T-15 TORX screwdriver
S
T-25 TORX screwdriver
Summary of Contents for Scalar AIT 440
