ADIC Scalar AIT 440, Installation And Operating Manual

Page: 193 / 205

Appendix B
170 Scalar AIT 440/480
105
480 KEY NOT PRESENT. The
library is missing the hardware
key. (This error applies to the
Scalar AIT 480 only.) Reseat the hardware key on the controller card at the
rear of the library.
Make sure the library and tape drives are not being
used by any host, then press
>5HVHW@
. If the error
persists, contact your service provider.
108
INCOMPATIBLE BOOT ROM.
The installed boot ROM is not
compatible with the flash
EEPROM code. You do not have the correct boot ROM for the
firmware you are trying to run in your library.
Contact your service provider.
109
CHECK CLEANER. The
cleaning cartridge was ejected
immediately after being loaded
into the tape drive. Replace the cleaning cartridge and try cleaning the
tape drive again. Make sure you are using the correct
type of cleaning cartridge for your tape drive. If the
error persists, contact your service provider.
Note: This error is only displayed if the cleaning was
requested from the LCD.
130 FAS216 ERROR; SCSI
UNEXPECTED INT; SCSI INT
STUCK ERROR. There is a SCSI
chip failure. Make sure the library and tape drives are not being
used by any host, then press
>5HVHW@
on the operator
panel.
If the error persists, contact your service provider.
You may be asked to supply a Diagnostic listing to
for diagnosis, and you may need a new controller
card.
131
132
133
134
135
136
137
Error Description Corrective Action