ADIC Scalar AIT 440, Installation And Operating Manual

Page: 145 / 205

Chapter 9
122 Scalar AIT 440/480
Cycle Pick/Place
The Cycle Pick/Place test picks a cartridge from the element you specify
and places it back in the same element. The test repeats the number of
times you specify. To run the Cycle Pick/Place test:
1. From the Diagnostics Menu, press
> @
or
> @
to select Cycle
Pick/Place and press
>(QWHU@
. The library displays the following
screen:
2. Press
> @
and
> @
to select the element index (shown in the upper
right corner) of the cartridge slot where you want the CHM to pick
and place the cartridge.
3. Press
>(QWHU@
. The library displays the following screen:
4. Press
> @
and
> @
to select the number of cycles, in increments of ten,
that you want the Cycle Pick/Place test to run.
5. Press
>(QWHU@
. The CHM picks and replaces the cartridge the number
of times you specified.
S e t S o u r c e 0
↑
I n c r e a s e
↓
D e c r e a s e
S e t C y c l e s 1 0
↑
I n c r e a s e
↓
D e c r e a s e