ADIC Scalar AIT 440, Installation And Operating Manual

Page: 53 / 205

Chapter 1
28 Scalar AIT 440/480
Step 10 – Connect the power cord
➤
Important
The power cord shipped with the library
is a 120 VAC three-conductor power cord for use in the
United States or Canada. If you are planning to use another
input voltage or if you plan to use the library outside of the
U.S. or Canada, you must supply your own power cord.
For more information, refer to
Appendix A .
1. Make sure that the power switch on the back of the library is off (the
0 is pressed ).
2. Connect the female end of the power cord to the power connector
on the back of the library.
3. Plug the male end of the power cord into the power source.
Note: The library has autoranging voltage selection, so you do not
need to change the voltage setting.
Step 11 – Power on the library
1. Make certain the library's door is closed and locked.
2. Turn on the host computer.
Note: If your host requires that attached peripheral devices be
powered on before the host, turn on the library before
turning on the host.
3. Push the power switch on the back of the library to the on ( I ) position.