ADIC Scalar AIT 440, Installation And Operating Manual

Page: 68 / 205

Configuring the Library
Installation and Operation 43
Setting the library time
The Set Time option allows you to set the time that is shown on the
library's Main Screen and Command History screen (see
page 144 ). To
set the time:
1. From the Configuration Menu, press
> @
to select Set Time and press
>(QWHU@
.
2. Use
> @
and
> @
to toggle through the selections under HH (hours),
MM (minutes), and SS (seconds). Use
> @
and
> @
to toggle between
the columns.
3. Press
>(QWHU@
to save your changes and exit the Set Time screen.
Checking the library serial number
The serial number is entered into the library firmware at the factory. If
you want to check that number, look at the serial number label on the
back of the library or use the Set Serial Number option. The serial
number displayed on this screen appears on diagnostic listings.
Note: If the serial number has never been entered, the number stored
in memory is 99999999.
S e t H H : M M : S S
T i m e : 2 0 : 2 2 : 0 9
↑ →
↓