ADIC Scalar AIT 440, Installation And Operating Manual

Page: 62 / 205

Configuring the Library
Installation and Operation 37
If you attempt to perform any of these operations when security is
enabled, the library displays a message that states security is active. The
message also states whether security was enabled from the operator
panel or by the application through a SCSI command.
Methods for enabling and disabling security
Security can be enabled and disabled in either of two ways:
S
You can set the Security option from the LCD on the operator panel
using the Configuration Menu, as described in this section.
S
The application software can issue a SCSI MODE SELECT
command to turn security on and off (see your software
documentation or the
Scalar AIT 440/480 Libraries SCSI
Reference ).
Note: SCSI MODE SELECT security prevents the same activities as
LCD security except opening the front door.
The method used to enable security (LCD or SCSI) must also be used
to disable security. That is, if you enable security from the operator panel,
you must disable it from the operator panel. If security is enabled by the
application (SCSI), it must be disabled by the application.
Note: To determine if security has been set by your application, look
at the SCSI Mode Parameters screen (see ).
Security remains in effect across library resets.