ADIC Scalar AIT 440, Installation And Operating Manual

Page: 187 / 205

Appendix B
164 Scalar AIT 440/480
The columns in the table indicate the following:
S
Error . The error code number, which appears on the library's
operator panel LCD when the error occurs.
S
Description. The error message that appears on the LCD, followed
by a more complete description of the error.
S
Corrective Action . The recommended corrective action or actions.
Error Description Corrective Action
10
DROPPED A CARTRIDGE. The
CHM dropped a cartridge. If the cartridge label was removed, make sure that
there is no label adhesive remaining on the cartridge.
If the label was not removed, contact your service
provider.
CAUTION: Do not try to put the cartridge back in
the gripper.
11
SOURCE EMPTY. There is no
cartridge in the source location. Install a cartridge in the source location, or redirect
the CHM to another location.
12
DESTINATION FULL. A
cartridge already exists in the
destination location. Remove the cartridge from the destination, or
redirect the CHM to another location.
13
PUT MECH. FAILURE. The
CHM could not successfully place
a cartridge because of mechanical
problems. Make sure there is nothing blocking the CHM or the
tape drives. If the error persists, contact your service
provider.
14
PICK MECH. FAILURE. The
CHM could not successfully pick
a cartridge because of mechanical
problems.
15 NO SRC ELEMENT; NO DEST
ELEMENT. No data cartridge
magazine was installed at the
selected location. Install a data cartridge magazine or redirect the
CHM.
16