ADIC Scalar AIT 440, Installation And Operating Manual

Page: 189 / 205

Appendix B
166 Scalar AIT 440/480
36
S LM629 RESET FAIL. The
library could not reset the servo
chip for the short axis. Make sure the library and tape drives are not being
used by any host, then press
>5HVHW@
on the operator
panel. If the error persists, contact your service
provider.
38
CANNOT LOAD DRIVE. The
CHM could not load the cartridge
into the tape drive. (It could not
move in far enough on the short
axis.)
S
Open the door and look for anything that
might be obstructing the CHM along its short
axis.
S
Make sure that a cartridge is not already
loaded in the tape drive.
S
Make sure that the flap on the cartridge is
closed.
S
Make sure the library and tape drives are not
being used by any host, then press
>5HVHW@
on
the operator panel. If the error persists,
contact your service provider.
40
L AXIS DOES NOT MOVE. The
CHM could not move along the
long axis. Open the door and look for anything that might be
obstructing the CHM along its long axis.
Make sure the library and tape drives are not being
used by any host, then press
>5HVHW@
on the operator
panel. If the error persists, contact your service
provider.
41
L AXIS FAILED HOME. The
CHM could not return to the home
position on the long axis.
46
L LM629 RESET FAIL. The
library could not reset the servo
chip for the long axis. Make sure the library and tape drives are not being
used by any host, then press
>5HVHW@
on the operator
panel. If the error persists, contact your service
provider.
50
D AXIS DOES NOT MOVE. The
drum could not move on its axis. Open the door and look for any obstructions around
the drum. If there are no obstructions, contact your
service provider.
51
D AXIS FAILED HOME. The
library could not determine the
home position for the drum. Contact your service provider.
Error Description Corrective Action