ADIC Scalar AIT 440, Installation And Operating Manual

Page: 188 / 205

LCD Error Codes
Installation and Operation 165
17
CHM FULL BEFORE MOVE.
There was a cartridge in the
gripper when the operator
powered-on or reset the library, or
before a move operation. Remove the cartridge and put it back in the cartridge
magazine if you know where it goes.
Make sure the library and tape drives are not being
used by any host, then press
>5HVHW@
on the operator
panel. If the error persists, contact your service
provider.
18
SRC CART INSIDE CTS. The
CHM could not successfully pick
a cartridge because it was still
loaded in the tape drive. Press the tape drive eject button and wait for the
cartridge to be unloaded, or redirect the CHM to
another location.
19
PICK MECH. FAILURE. The
CHM could not successfully pick
from a full cartridge slot. Open the door and look for anything that might be
obstructing the gripper.
Make sure the library and tape drives are not being
used by any host, then press
>5HVHW@
on the operator
panel. If the error persists, contact your service
provider.
21
GRIP HOME ERROR. A gripper
error occurred.
22
GRIP MOTION TIMEOUT. A
gripper motion took longer than
the maximum time allocated for it.
When motion functions do not
complete in the allocated time, the
current to the servo motors is shut
off.
25
PICK STALL. The CHM stalled
while trying to pick a cartridge
from the tape drive.
26
CANNOT OPEN GRIPPER. The
gripper could not open.
30
S AXIS DOES NOT MOVE. The
CHM could not move along the
short axis. Open the door and look for anything that might be
obstructing the CHM along its short axis.
Make sure the library and tape drives are not being
used by any host, then press
>5HVHW@
on the operator
panel. If the error persists, contact your service
provider.
31
S AXIS FAILED HOME. The
CHM could not return to the home
position along the short axis.
Error Description Corrective Action