ADIC Scalar AIT 440, Installation And Operating Manual

Page: 104 / 205

Maintaining the Library
Installation and Operation 81
If your library has a narrow SCSI configuration, use the narrow SCSI
drive blank. If your library has a wide SCSI configuration, use the wide
SCSI drive blank.
Note: The library is shipped with one extra drive blank in the accessory
box.
Procedure for replacing tape drives
To replace a tape drive, complete the steps listed in the table below. Each
step is described on the following pages.
Note: In these instructions, tape drive refers to a tape drive installed
in a drive carrier.
Step 1 – Prepare for replacement procedure
1. Obtain a flat-blade screwdriver.
2. To avoid damaging the library, be sure that the work area is free of
conditions that could cause electrostatic discharge (ESD). See
page
3 .
3. Turn the key in the lock.
Step Description
1 Prepare for replacement procedure.
2 Remove the tape drive from the library.
3 Install a drive blank or tape drive in the library.
4 Resume library operations.