ADIC Scalar AIT 440, Installation And Operating Manual

Page: 88 / 205

Operating the Library
Installation and Operation 63
7. Insert the bottom end of the magazine first, then snap the magazine
into place by pressing against the top.
8. Close the door and lock it by turning the key a quarter turn to the
left. After the door is closed:
S
The library performs its power-on self-test.
S
The library returns Unit Attention status to the host.
S
The software may update its own cartridge inventory.
Resetting the library
If the library has encountered an error and is still not operating after you
have tried the corrective action for the error, you may need to reset the
library. A reset causes the library and the tape drives to perform their
power-on self tests. Unless configured otherwise, tape drives will rewind
the tape after a reset, but will not eject the data cartridge.
Note: If the library is performing a cartridge move operation when it
is reset, it completes the move operation before it performs the
power-on self-test.
As described in this section, you can use any of the following methods
to reset the library and tape drives:
S
Press
>5HVHW@
on the operator panel
CAUTION
Before resetting the library, make sure the library
or tape drives are not communicating across the
SCSI bus. Resetting the library and tape drives
may disrupt communications on the SCSI bus.