ADIC Scalar AIT 440, Installation And Operating Manual

Page: 192 / 205

LCD Error Codes
Installation and Operation 169
80
E/E FAILED TO EXTEND. The
entry/exit port could not be
extended. Open the door and look for obstructions around the
entry/exit transport arm. If there are no obstructions,
contact your service provider.
81
E/E FAILED TO RETURN. The
entry/exit port could not be
retracted.
90
INVALID BLANK CONFIG. The
drive blank configuration is
invalid. This error applies to earlier models of the library
only. If you operate the library with fewer than four
drives, you must have drive blanks installed in the
empty slots. Tape drives must be installed in
contiguous slots, starting with the top slot.
91
OPERATOR ABORTED. A
diagnostic was aborted while it
was in progress. No corrective action required.
97
DRIVE NOT INSTALLED. The
tape drive could not be cleaned
because no tape drive is installed
in this location. This error only appears on the Clean Drives Menu.
If no tape drive is installed in the location, redirect
the CHM. If a tape drive is installed, make sure that
the drive carrier is correctly seated. If the error
persists, contact your service provider.
98
NO MAGAZINE. There is no
magazine installed in this location. If no magazine is installed in that location, redirect
the CHM. If a magazine is installed, make sure that
it is correctly seated on the mounting plate. If the
error persists, contact your service provider.
101
DRUM MOVE, SAXIS EXT. The
CHM could not move along the
short axis. Open the door and look for anything that might be
obstructing the CHM along its short axis.
Make sure the library and tape drives are not being
used by any host, then press
>5HVHW@
on the operator
panel. If the error persists, contact your service
provider.
104
DRIVE DID NOT EJECT. The
CHM timed out waiting for a tape
drive to eject a cartridge. There may be a problem with the tape drive. Contact
your service provider.
Error Description Corrective Action