ADIC Scalar AIT 440, Installation And Operating Manual

Page: 107 / 205

Chapter 6
84 Scalar AIT 440/480
Step 3 – Install the tape drive
³
Important
Do not insert your fingers in the tape
drive door.
1. As shown in Figure 6-1 , insert the tape drive into the slot with the
lever to the right. Make sure the lever is closed. The tape drive should
slide easily toward the back.
2. When the drive is almost completely inside the slot, you will feel
some resistance. This is caused by the connection between the
library's controller card and the tape drive. To seat the connection,
push firmly against the drive until you can push no further.
3. Using a flat-blade screwdriver, tighten the captive screw on each
end of the drive carrier faceplate (two screws).
Step 4 – Resume library operations
1. Connect the power cord to the back of the library and to the outlet.
2. Close and lock the library's door.
3. Turn the library power switch to on.
Note: When you replace a tape drive, the new tape drive
automatically assumes the SCSI ID of the old tape drive.
See
page 34 if you want to change the ID.