ADIC Scalar AIT 440, Installation And Operating Manual

Page: 43 / 205

Chapter 1
18 Scalar AIT 440/480
Install data cartridges in the magazines
1. Place the magazine on its feet with the single mounting guide toward
the right, as shown in
Figure 1-13 .
2. Position each cartridge so that the bar code label is on top and the
write-protect switch is toward the front.
3. Insert the cartridge into the magazine slot.
Note: Very little force is needed to install a data cartridge. If it does
not snap into place easily or if it protrudes further than the
magazine’s center rib, check the orientation of the cartridge.
Figure 1-12 Setting the write-protect switch on a data cartridge