Unexpected vacuum loss in case of a suctioned workpiece!
Risk of fatal injury due to workpiece crashing!
Ø
No permanent workplace is permitted outside the safety
fencing within the swivel range of the BendMaster.
Ø
Follow the safety regulations for handling heavy loads.
Ø
Do not enter the danger zone when a workpiece is attached
by suction.
Ø
Do not fail to follow any of the following instructions.
■
Never manually guide a load suspended from the BendMas-
ter out of the danger zone or manually guide it into the dan-
ger zone.
■
In the event of a power failure:
−
Wait until the power supply has been restored.
−
Securely deposit the workpiece on a pallet.
■
If there is a defect directly at the BendMaster that requires
repair work in the danger zone:
−
Secure the suspended load from above using a crane
and remove it.
or
−
Drop the suspended load with the safety doors closed
before entering the danger zone.
■
If there is a defect to the system outside the danger zone:
−
Eliminate the defect.
−
Deposit the suspended load on a pallet.
■
Do not move the BendMaster with suspended loads into the
home position in order to enter the danger zone afterwards.
Set down the workpiece first.
In manual mode (for example, teach mode), the operator may be
within the safety fencing to move the axes of the robot and the
press brake.
If the compressed air fails, an acoustic warning signal is emitted
in manual mode and a cyclic error message is displayed at the
HMI. The BendMaster stops and can no longer be moved in
manual mode.
Unexpected drop in pressure at the BendMaster gripper
while a workpiece is clamped!
Risk of injury due to workpiece falling down.
Ø
If an acoustic warning signal is emitted, exit the automation
cell immediately and close the safety doors.
Ø
Acknowledge the message.
Ø
Before entering the safety cabin: move the BendMaster
manually and set down the clamped workpiece safely.
1
‐
10
Hazards
2015-06-01
B579EN
DANGER
In manual and automatic
mode
Additionally, in manual mode
WARNING
Содержание BendMaster 150
