Trumpf BendMaster 150, Руководство оператора

Страница: 105 / 258

2. Operating the BendMaster
2.1 Safety information
Workpiece is suspended from the suction cup of the
BendMaster!
The workpiece can fall down if the power supply is discon-
nected or if the vacuum is reduced.
Ø Only turn off the MAIN SWITCH and the compressed air
supply if no workpiece is suspended from the vacuum grip-
per of the BendMaster.
If the compressed air fails, an acoustic warning signal is emitted
in manual mode and a cyclic error message is displayed at the
HMI. If a sheet is gripped, the operator must exit the automation
cell immediately and close the safety doors, because the blank
could be released from the gripper.
Workpiece is suspended from the suction cup of the
BendMaster!
The workpiece may fall down if the vacuum is reduced.
Ø If the warning signal is emitted, exit the bending cell immedi-
ately and close the safety doors.
2.2 Status display
The different statuses of the control are indicated by symbols at
the top left of the HMI user interface.
Icons Status
■ Green padlock, open: write permission granted.
■ Red padlock, closed: no write permission.
Hand: manual operating mode is active.
Arrow: automatic operating mode is active.
Circle: zero position operating mode is active.
TruBend manual operating mode (without BendMas-
ter).
BendMaster/regripping station ready for operation
(green).
B579EN
2015-06-01 Operating the BendMaster
4
‐
11
WARNING
WARNING